Chicago, Illinois | CPO 130 | none unit dead | will not power on
It was failing earlier, with beeping after 30 seconds of being turned on. I did not look for a code when it was malfunctioning. | Repaired |
Chicago, Illinois | CPO 130 | dead unit | will not turn on | Repaired |
Mississauga, Ontario | CP0130WC | F1 | as soon as i turn the circuit power on,after a minute or so oven fan comes on then starts beeping it stops when i push cancel or timer button then shortly like 30 seconds fan comes on again starts beeping .if i turn on oven it does work only for a minute then it starts beeping sound. | Beyond Repair |
Arlington, Virginia | CPO 130 | N/A | Heat Elements not Working - the oven can be set to a temperature, the process appears to start correctly, but the heating elements never turn on and after about 10 seconds the oven shuts off.
Note: previously, we had seen a "failure" code of some sort after using the oven in broil mode; also, the oven would "beep" every few seconds for a few minutes thereafter. | Repaired |
Atascadero, California | CPO130B | N/A | CONTROL HAS NO DISPLAY. HOWEVER, OVEN CAN BE TURNED ON "BLIND" AND DISPLAY BECOMES VISIBLE AFTER OVEN WARMS A BIT. ALSO, I FOUND TEMPERATURE CONTROL KNOB UNRESPONSIVE. | Replaced with reconditioned timer |
Van Nuys, California | CPO130W | temperature not stay | unresponsive control setting | Repaired |
Peabody, Massachusetts | Dacor CPO-130 | N/A | Wont' hold temperature setting...kicks the oven "off". | Repaired |
bowen island, British Columbia | CPO130BC | N/A | Time/temperature control knob does not work. | Awaiting receipt of timer |
Concord, California | KSRB25OGSS01 | N/A | Display flickers and fades | Repaired |
Bakersfield, California | Dacor 82874 | N/A | When the oven is turned on, it turns off after a couple of seconds. If we turn it on 10 to 15 times consecutively, it may then stay on. | Awaiting receipt of timer |
Bakersfield, California | Dacor 82874 | N/A | When the oven is turned on, it turns off after a couple of seconds. If we turn it on 10 to 15 times consecutively, it may then stay on. | Awaiting receipt of timer |
Bakersfield, California | Dacor 82874 | N/A | When the oven is turned on, it turns off after a couple of seconds. If we turn it on 10 to 15 times consecutively, it may then stay on. | Awaiting receipt of timer |
Bakersfield, California | Dacor 82874 | N/A | When the oven is turned on, it turns off after a couple of seconds. If we turn it on 10 to 15 times consecutively, it may then stay on. | Awaiting receipt of timer |
Chico, California | CPO130 | N/A | Clock can not be set, timer does not work. The lights on the right of the oven knob remain on. See attached drawing in shipment | Beyond Repair |
Hopkins, South Carolina | CPO130b | N/A | When the oven is turned on it starts into the preheat cycle for just a second and then shuts down. The selector lights stays on but the display reverts back to display the time. I have attempted to restart the oven cycle multiple times and after 30 to 45 minutes of restarts it may start the oven cycle and heat up the oven. Per one of your techs I have ohmed the temperature sensor with a reading of 1075 ohms at room temp. | Repaired |
Arroyo Grande, California | Dacor CP0130 | N/A | Shuts off while preheating. Sometimes when the convection is set, it will eventually heat the oven. Rarely works on the first try. | Awaiting receipt of timer |
Long Beach, California | CPO130 | F1 | Intermittent F1 alarm on oven | Awaiting receipt of timer |
Wheaton, Illinois | Convection Plus CPO130 | N/A | I have a Dacor convection plus wall oven CPO130. It has power, it turns on when switched on, but then immediately shuts down. Power remains on panel, but heating element doesn't get hot and exhaust fan doesn't run. No failure code. This problem occurred one time last year, then didn't reoccur until now. | Beyond Repair |
Strongsville, Ohio | | N/A | The timer does not work | Awaiting receipt of timer |
claremont, California | cpo230 | f1 | Fi error code: element relay circut failure | Beyond Repair |