82648MODELB408 Dacor Range/Stove/Oven Timer Repair

Failure codes, problems, and resolutions for Dacor timer model # 82648MODELB408
Dacor ERCs and Dacor stove clocks and timers Manufacturer :  Dacor
Part Number :  82648MODELB408
Appliance Type :  Range/Stove/Oven
Color : 
Description :  Electronic Range/Oven Timer
 
 
Do you have a failed Dacor 82648MODELB408 timer?
Click here:
We can repair or replace your faulty 82648MODELB408 timer.		 Request Appliance Timer Service

Recent Service Requests for Dacor Part Number 82648MODELB408

CityModel NumberFailure CodeProblem DescriptionResolution
RENO, NevadaW-305N/AWhen trying to set temp clock goes to 12:00 and blinks and am not able to set temp.Repaired
Orange, CaliforniaW305SE1Heats for approx 10 minutes. Then goes to SE1 code Reset circuit breaker Worked for 10 minutes Then 8888 symbols appeared and heating stopped again Most of the time it... fails to SE1 code Note: was repaired about 5 years ago for failure problemsTimer inspected, no repairs necessary
Longmont, Coloradow305bnonecloudy temp readout and eratic oven behaviorAwaiting receipt of timer
Doylestown, PennsylvaniaW305SEO & SE1First had error code SEO . Replaced Sensor. Oven heated to pre set temperature, ran for a while then turned off. Received. error code SE1 . Oven also turned off before reaching pre set temperature. Temperature sensor resistance reading including wires is 1.084 K ohms. Temperature. Setting knob also broke off and needsto be replacedRepaired
Mill Valley, CaliforniaN/AThe LED readout for the clock/timer/temp setting would be intermittantly visible, usually coming to life after pushing the buttons repeatedly, or holding them in for a few seconds. When the oven was not in use, the clock readout was usually not lit up as it should've been. These conditions lasted several years. The oven itself works fine. However the LED readout now has failed to light-up at all, so we have no way to set the desired oven settings in order to cook.Repaired
Palo Alto, CaliforniaW305Rot. control knob meRotary position sensor to control temperature etc. is broken off, and now stuck as a result of repeated temporary repairs. It needs to be replaced. The electronics have been working fine.Repaired
Newport Beach, CaliforniaW305None - temp dial skiWhen I turn either the time or temperature dial, the digits skip around.Repaired
Saint John, New Brunswickw305N/ATime/Temp control knob does not work properly. Instead of allowing you to dial in the temperature or time setting desired, the numbers bounce around up and down randomly. Please thoroughly check all functions of the unit.Repaired
Macungie, PennsylvaniaW305N/AStem broken off for temp set control knob and digital display doesn't light up.Repaired
las vegas, NevadaunknownHa1d local repair co come out. They said I needed new clock/timer. Sent it in to Core Centric and they cannot repair it. Do you have a reconditioned replacement?Awaiting receipt of timer
Escondido, CaliforniaDacor W305N/AWhen using rotating knob to set; oven temperature, minute timer or clock the display is erratic. Part number is from the back of the module I'm sending to you. Not sure if that is the Dacor Part NumberRepaired