| Ottawail, Illinois | Cga4d59tzk | N/A | No bake no broil , ignitors ,gas valve , thermister all have bee n checked , timer control flags are not functioning ???? | Awaiting receipt of timer |
| Fort Wayne, Indiana | 34MN-3TKXW ON | none | Warranty claim, invoice # 103049. You can call me at 260-451-6096.
The oven and broil does not work at all. The same problem in when was shipped to you in September 2011. | Beyond Repair |
| Rhinelander, Wisconsin | 34mn-3tkxw | none | doesn't control oven temperature consistently, once when oven was set to 500 it didn't shut burner off and internal temp rose well above 600. internal oven temp is usually lower than what it is set to but not at a consistent amount. | Repaired |
| Plymouth, Massachusetts | | N/A | Bake relay cycles and eventually stops oven. Was intermittent but now very difficult to get bake going.
Existing timer was repaired by you previously.
Timer serial number 0047204 | Awaiting receipt of timer |
| Fairbury, Illinois | 34MN-5TKXW | N/A | Ever since a power surge, the buttons to set the time, turn on the oven, set the baking time have no effect.
The timer does power up and initially shows "10:-3". Pressing the clear button takes it to the time, which of course is incorrect and as mentioned cannot be set. | Awaiting receipt of timer |
| Dassel, Minnesota | 34MN3TKVW | none displayed | Timer has lost accurate functionality. Display indicates a quick temperature rise and stops the flame at anywhere from 75 - 300 degrees below the setpoint. The temperature sensor was replaced but the same conditions is present with the new sensor. | Repaired |
| Canastota, New York | 34ma-3tkxw | originally F3, now s | While on and baking at 350, the stove beeped and showed code F3. Cycled the power to the stove and the code now shows "10:-3". The stop/clear button will remove the code and resume the clock. No other buttons work anymore. I replaced the oven sensor even though it tested fine at 1100 ohms since the original code was F3, but that did not matter, the controller appears to have failed. | Awaiting receipt of timer |
| Somerville, Massachusetts | 34JN-3TKXW | N/A | When trying to turn on the oven, the temperature can be set but then after a brief time it resets without the oven igniting. | Repaired |
| LAFAYETTE, Indiana | | N/A | The timer failed to power up. Upon taking the timer out of the stove a large 1000uF 35V capacitor came off the board. Replaced the two 10000uF caps and the unit cam on initially and now doesn't come back on. It looks to be a power supply issue. The diodes were test (on the c/b) and seem to be ok. Can a power supply c/b (only) be purchased? If not, how much is a new timer (7601P181-60) and/or how much is a new one> | Awaiting receipt of timer |
| Fort Wayne, Indiana | 34MN-3TKXW ON | none | neither oven or broil ignitor will light. Therefore the oven or broil will not work. | Repaired |
| MILFORD, Connecticut | GAS STOVE | DOES NOT DISPLAY FAI | (#1) ACTUAL STOVE TEMPERATURE DOES NOT REACH ELECTRONIC CONTROL SET TEMPERATURE. (#2) SEVEN BLACK TRIANGULAR BUTTONS DO NOT FULLY COME OUT AFTER PRESSING. (#3) SMALL ROUND BLACK STOP / CLEAR BUTTON DOES NOT FULLY COME OUT AFTER PRESSING AND NEEDS TO BE PULLED OUT AFTER PRESSING, AND BEFORE USING STOVE EACH TIME. | Repaired |
| MILFORD, Connecticut | GAS STOVE | DOES NOT DISPLAY FAI | (#1) ACTUAL STOVE TEMPERATURE DOES NOT REACH ELECTRONIC CONTROL SET TEMPERATURE. (#2) SEVEN BLACK TRIANGULAR BUTTONS DO NOT FULLY COME OUT AFTER PRESSING. (#3) SMALL ROUND BLACK STOP / CLEAR BUTTON DOES NOT FULLY COME OUT AFTER PRESSING AND NEEDS TO BE PULLED OUT AFTER PRESSING, AND BEFORE USING STOVE EACH TIME. | Repaired |
| Long Beach, California | 34ma3tkxw | N/A | stop/clear button broke off inside clock. I am unable to remove it to put the new one in | Awaiting receipt of timer |
| MILFORD, Connecticut | GAS STOVE | DOES NOT DISPLAY FAI | (#1) ACTUAL STOVE TEMPERATURE DOES NOT REACH ELECTRONIC CONTROL SET TEMPERATURE. (#2) SEVEN BLACK TRIANGULAR BUTTONS DO NOT FULLY COME OUT AFTER PRESSING. (#3) SMALL ROUND BLACK STOP / CLEAR BUTTON DOES NOT FULLY COME OUT AFTER PRESSING AND NEEDS TO BE PULLED OUT AFTER PRESSING, AND BEFORE USING STOVE EACH TIME. | Repaired |
| Dallas, Texas | CWE5500BCE | F1 | Oven takes 8-10 tries to light using timer controls, then when turned off, timer beeps
with "F1" displayed until CANCEL is pressed. This may happen 5 or more times before alarm is finally canceled. Unplugging/replugging power usually resets timer for one use, then problem recurs. | Repaired |
| Highland, Michigan | 34MA-5TKVW | N/A | I have put in a new sensor but the temp. is about 150 degrees lower than display. | Repaired |
| FRANKLIN, Wisconsin | 34JA-3TKXW ON | N/A | I set temp range to 350 degree, readout indicates 180 degrees, igniter lights gas, readout climbs to 350 degree in 30 seconds and gas shuts off. Oven is 100 degrees and readout indicates 350 degree. | Awaiting receipt of timer |
| Oswego, Illinois | 34jn-3tkxw | none | The oven shuts off at a temperature way below the set tempurature. I replaced and tested the sensor and if I set the control to 300 degrees and turn on the oven it will get to 300 degrees on the clock quickly but the temp inside the oven is only about 150 degrees. The ohms reading on the sensor was about 1250. The gas does turn on and burn while the temp increases until the oven clock reads 300. The only conclusion I can come to is that the electronics in the clock module are not reading the signal from the sensor properly and turning off the gas prematurely. | Awaiting receipt of timer |
| Lewiston, Idaho | 34JA-3tkxw on | N/A | No display or oven control. | Repaired |
| Plymouth, Massachusetts | 34MN-3TKXW-ON | N/A | Oven controls baking temperature way below setpoint. Off by more than 100F when oven first cycles then difference gets less (50-75F) after on for >1/2 hour. Oven thermostat has already been replaced and wiring to controller from thermostat is verified in good physical and electrical condition.
Email is best contact method.
Thanks!
Ed Block | Repaired |
Established in
