7601P17560 Magic Chef/Maytag/Magic Chef Range/Stove/Oven Timer Repair |
Failure codes, problems, and resolutions for Magic Chef/Maytag/Magic Chef timer model # 7601P17560 |
|
Manufacturer : |
Magic Chef/Maytag/Magic Chef |
Part Number : |
7601P17560 |
Appliance Type : |
Range/Stove/Oven |
Color : |
|
Description : |
Electronic Range/Oven Timer |
|
Do you have a failed Magic Chef/Maytag/Magic Chef 7601P17560 timer? Click here: We can repair or replace your faulty 7601P17560 timer. |
|
Recent Service Requests for Magic Chef/Maytag/Magic Chef Part Number 7601P17560City | Model Number | Failure Code | Problem Description | Resolution |
---|
Windber, Pennsylvania | 38HA 6TVW Code EV | N/A | Clock fades in and out can’t reset it or set oven temperature or any of the buttons | Awaiting receipt of timer | Caledonia, Wisconsin | 38HA-6TVW | N/A | Either new or reconditioned. | Awaiting receipt of timer | Kensington, Maryland | 38HA6TVW EV | N/A | The burners work. The oven/broiler does not work. Repairman came. Said bad part is the ELECTRONIC CLOCK. Couldn’t find a new part online. Gave me the part number. Suggested it might be able to be repaired. | Repaired | Westport, Massachusetts | 38ha-36tx | no code | The oven does not start. You set it but after several seconds display goes blank. The timer will make a buzzing sound if you press the button again just before it goes off. | Beyond Repair | Scott Township, Pennsylvania | 38HN-36TX | None | Oven will shut off before reaching desired bake temperature. | Repaired | Bay City, Michigan | 38HA-6TVW | NA | When oven temperature is set the oven does not reach desired temperature. Maximum temp may reach approximately 100 degrees even when set to maximum temperature. | Repaired | Helotes, Texas | | N/A | TEMPERATURE IS SET - OVEN STARTS THEN SHUTS OFF PRIOR TO REACHING TEMPERATURE . NEED TO HOLD DOWN BAKE TEMP BUTTON UNITL TEMP GOES ABOVE 250 BEFORE IT STAYS ON | Awaiting receipt of timer | Vancouver, Washington | | none | oven shuts off after setting pre-heat temp or fails to reach internal temperature shown on digital readout | Awaiting receipt of timer | Cave Creek, Arizona | | None Shown | The controller does not get the oven temperature up to the correct level | Repaired | HAZLE TWP, Pennsylvania | LCRE805 | N/A | HIGHEST TEMP WILL ONLY REACH 350*, CAN SET TO 550*, BUT WILL NOT REACH TEMP. TEMP OFF BY 200* | Awaiting receipt of timer | alborn, Minnesota | 38ha-36tx | n/a | Checked both elements and replaced oven probe but oven still shows wrong temp | Awaiting receipt of timer | Bethany, Oklahoma | 38HN-36TX | None | Actual Oven Temperature is Approx. 120-140 Degrees lower that the Controller displays. Starts out with cold oven readign 190-220 degrees. Temperature Display rises even though the thermocouple is not inside the oven.
Replaced Thermocouple Sensor with same results. | Repaired | Westfield, New York | 38HK-6TXW | unknown | cannot turn on oven or anything related to oven use. also cannot set clock | Beyond Repair | Norton, Massachusetts | 38HK-6TXW | F1 | Oven will not reach full temperature when set at 400 only reached 200. | Awaiting receipt of timer | jacksonville, Illinois | lcre775 | N/A | bake temperature button sticking on, while on board sparks and buzzes | Repaired | Warren, Michigan | 38ha-36tx | N/A | Thermal sensing probe has been checked and is good.
I set oven to 400 degrees and I get 275 degrees. | Repaired | Camak, Georgia | 38HN-36TX | N/A | Oven will not come on (most of the time). If it does come on, it will go right back off. Occasionally it will work. Were told to purchase new control board to fix problem. Have not been able to locate replacement control board. | Repaired | Fairport, New York | 38HN-36TX | none | The oven temperature is too low. When the timer is set at 350 degrees, the actual oven temp is 175 degrees; when set at 505 degrees, the actual oven temperature is 275 degrees. The problem is NOT the oven sensor. I changed the sensor and the problem continued. The problem is not the heating element since it glows red-hot. The timer is shutting off the element too soon. | Repaired | Clinton, Tennessee | Maytag Self Cleaning Oven | N/A | Bake element does not work. Relay does not activate for Bake cycle | Repaired | athens, Washington | bcre955 | N/A | i just want to order the part u have in stock, already verified thst u have it in stock, i will send u the bad unit right after i get the reconditioned one fromu guys. | Repaired |
|