71002123 Maytag/Jenn-Air Range (Stove, Oven) Timer Repair

Failure codes, problems, and resolutions for Maytag/Jenn-Air timer model # 71002123

Maytag ERCs and Maytag stove clocks and timersJenn Air ERCs and Jenn Air stove clocks and timers Manufacturer :  Maytag/Jenn-Air
Part Number :  71002123
Appliance Type :  Range (Stove, Oven)
Color : 
Description :  Clock control

 
 
Do you have a failed Maytag/Jenn-Air 71002123 timer?
Click here:

We can repair or replace your faulty 71002123 timer.
Request Appliance Timer Service

Clock control timer Part Number 71002123 is used in the following appliances

Recent Service Requests for Maytag/Jenn-Air Part Number 71002123

CityModel NumberFailure CodeProblem DescriptionResolution
San Jose, CaliforniaCWE7800ACEnonearrow "up" button broken. believe plastic button piece has broken off. sending the broken piece.Repaired
denton, TexasW27100WN/AHello! The oven will only go up to 350 degrees when you try to set it to a higher temperature. Do you have any of these parts on hand for purchase? We need it asap and could then send in ours if needed. Look forward to hearing from you! 817-5xx-xxxx t...@gmail.comAwaiting receipt of timer
Redwood City, CaliforniaW27100Bn/aOven exhibits no signs of life except for hum. Previous inquiry 12/29/21 2:10PM Pacific Oven failed after wide area power outage. Now no lights or anything other than low frequency hum. Service rep said likely control panel or relay. Timer failure consistent with your site page about this timer (nice touch by the way).Repaired
Scandia, MinnesotaWM27160Wwont set temp..goes wont set temp..goes to broil do you have any in stock?Repaired
Little Meadows, PennsylvaniaCWE6800ACENo code, BAKE buttonBake button does not work/. Ser # 12084730UQRepaired
Livonia, MichiganCWE6800ACBN/Atemp up arrow doesn't work temp down arrow is intermittantRepaired
Charleston, South CarolinaW27100WN/Athe oven will only go up to 350 degrees when you try to set it to a higher temperatureRepaired
Caldwell, TexasW27100wF2Oven comes on and want turn off, and touch pad won’t work unless breaker is turned off. Then after sitting overnight turn breaker on then it may or may not work. F2 code every now and then. Before this broiler would not work. Please contact me! I need to ask some questionsAwaiting receipt of timer
Greens Fork, IndianaW27100WN/ATemperature selector for increasing not workingAwaiting receipt of timer
Skiatook, OklahomaW27100WN/AUp down arrows to change temperature, run timer, etc. stopped working. Upon removal of timer, see that button top and connector below were broken off for this functionRepaired
Andover, Connecticutw27100wN/Atakes forever to heat up then will not stay at a temperature go higher or shut off.Repaired
Baton Rouge, LouisianaW27100BN/ANo clock, no display, key pad won't function, no sound, power is good.Repaired
Comanche, TexasCwe7800aceN/ACan't increase heatingRepaired
ceres, Californiacwe7800 aceN/Awhen you press bake it jumps to broil every time. top oven not workingRepaired
marshall, VirginiaN/Aoven bake will not come one it goes tobroilAwaiting receipt of timer
Fort Worth, TexasW27100Wpower surge from powControl board/panel does not power up. Failure due to power outage from power company and subsequent surge when power restored to house. Smells like burnt bakelite.Awaiting receipt of timer
Chantilly, Virginiaww27110BF2During baking, Broiler will turn on and create an overheat condition. Usually, we can turn off the breaker, let the oven cool, and then turn it back on. Recently, the broiler now turns on immediately when power is restored to the oven.Replaced with reconditioned timer
Poulsbo, WashingtonWW27110F2Broiler coil is stuck on. If new or reconditioned oven control board is not available, we are willing to consider sending ours in for repair.Repaired
Indianapolis, Indiana9855vvvN/Ahad a buzzing noise and went blankRepaired
Aurora, Ohioww27110wf-2power outage-power restored- turned top oven on to bake -got code of f 2 shuts off bake and broiler turned on in top oven. contact points in one of the relays look in poor conditionAwaiting receipt of timer