343912 General Electric/Kenmore Range (Stove, Oven) Timer Repair

Failure codes, problems, and resolutions for General Electric/Kenmore timer model # 343912

General Electric (GE) ERCs and General Electric (GE) stove clocks and timersKenmore ERCs and Kenmore stove clocks and timers Manufacturer :  General Electric/Kenmore
Part Number :  343912
Appliance Type :  Range (Stove, Oven)
Color : 
Description :  Electronic clock control - Discontinued by the manufacturer

 
 
Do you have a failed General Electric/Kenmore 343912 timer?
Click here:

We can repair or replace your faulty 343912 timer.
Request Appliance Timer Service

Recent Service Requests for General Electric/Kenmore Part Number 343912

CityModel NumberFailure CodeProblem DescriptionResolution
Madison, Virginia911.4698814F7Stove was "beeping" at which time I saw the error code F7. Upon turning the circuit breaker off, then back on, the stove beeps and the word "door" is shown on the display. After approximately 10 seconds, the word "door" disappears and the error code F 7 appears!Timer inspected, no repairs necessary
Seaford, Delaware931 4698815N/AOven cancel switch loose , timer set switchAwaiting receipt of timer
Washington,, District of Columbia911-4698814F 1All the functions work for about 10-15 seconds and then an F 1 display with beeping occurs. We spoke this moring and I checked the push buttons.Beyond Repair
Fairfield, Pennsylvania911.4698815UnknownRange LED control face does not display digits for oven temperature correctlyBeyond Repair
Amarillo, Texas911.4698815N/ANone of the oven buttons work, don't even make a beep sound when pushed.Replaced with reconditioned timer
Richmond, British ColumbiaClassic Grille Slide-In 911-4698813F5I am getting (F1 or) F5 errors (which I had been able to avoid or delay by running the fan while using the oven), and the lower element does not seem to work now (broil seemed OK). The resistor coatings are a bit corroded. Only once, I heard a buzzing sound from under the oven when I turned it on which must have been a solenoid--I pulled that box out and things looked brand new so I am thinking at that moment, the control panel wasn't sending enough current to properly activate the solenoid.Beyond Repair
Maberly, OntarioClasic Grill 911.48781C1F3 solid now. F2 preF3 code always on Bake or Broil with temperature sensor plugged in or disconnected. Previously we have had F2 codes that cleared after the oven cooled. A new temperature sensor was installed lately.Replaced with reconditioned timer
Maberly, OntarioClasic Grill 911.48781C1F3 solid now. F2 preF3 code always on Bake or Broil with temperature sensor plugged in or disconnected. Previously we have had F2 codes that cleared after the oven cooled. A new temperature sensor was installed lately.Replaced with reconditioned timer