| Seminary, Mississippi | 30" single wall oven | Contractor lose caus | One of the connectors to the board appears to have broken, causing it to short the board out and spark. Need new relay board. | Awaiting receipt of timer |
| St. John's, Newfoundland and Labrador | C970-441933 | Na | Looking for replacement part | Awaiting receipt of timer |
| Sault Ste Marie, Ontario | 970C670220 | None | Oven did not heat up past 175 degrees. Stove top still works fine. | Repaired |
| Kamloops, British Columbia | 970-698380 | N/A | No power to oven elements | Repaired |
| Brigden, Ontario | C970-440935 | N/A | Oven won’t heat | Repaired |
| Winnipeg, Manitoba | 970C670220 | none | No Oven Heat. | Awaiting receipt of timer |
| London, Ontario | Kenmore Elite | F10 | Run away temperature. Error F10. Disconnected power and retried. Same error. | Repaired |
| Souris, Manitoba | 970C653120 | F15 | F15 . assuming power surge, I was not home at the time but the surge also destroyed 2 power bars. Top elements and closck work, oven does not, when pressed button for any oven function, F15 appears. | Awaiting receipt of timer |
| Middle Sackville, Nova Scotia | 970-678595 | F10 | Oven run away temp | Awaiting receipt of timer |
| st. john's, Newfoundland and Labrador | c970-441933 | na | Bake oven sometimes dose not seem to work. When I check the voltage on the element it only reads 120v. Other times the oven runs hot, up to 550. Note that I use an oven thermometer to check temperature. Note also that P3 has loose pins. I couldn't remove the connector so I may have done that while trying to remove the connector. Instead I have to snip the wires. | Repaired |
| Calgary, Alberta | 970-678432 | N/A | There was shock, sound like an explosion. The time is blank and doesn't respond to a touch. There is voltage to the board. | Repaired |
| Calgary, Alberta | 970-678432 | N/A | There was shock, sound like an explosion. The time is blank and doesn't respond to a touch. There is voltage to the board. | Repaired |
| Dieppe, New Brunswick | Range | N/A | Damaged | Awaiting receipt of timer |
| Little Bay, Newfoundland and Labrador | 970-687-620 | N/A | The Oven was not heating up to temperature . Only slightly.
when I removed the timer; the solder on the main connector the solder was melted from around one of the connects. repaired this and put back in the power came back on the Oven but when
I trurned on bake the resistor melted, you can see the damage on the connector & relay board. | Awaiting receipt of timer |
| Little Bay, Newfoundland and Labrador | 970-687-620 | N/A | oven only heats to 125 degrees The relay on the relay board was blown out. Looking for the relay board P/No. 3164627 | Awaiting receipt of timer |
| Little Bay, Newfoundland and Labrador | 970-687-620 | N/A | Oven only heat to 150 degrees | Awaiting receipt of timer |
| High River, Alberta | gallery series | N/A | No power. Main power terminal fried | Awaiting receipt of timer |
| Fountain Inn, South Carolina | | N/A | Surface works/oven don’t | Awaiting receipt of timer |
| Nakusp, British Columbia | 970C670121 | none | oven will not heat. No failure codes. Back of board shows obvious burn marks. | Repaired |
| Fort Saskatchewan, Alberta | CPLEFMZ9GCG | none | Burnt resistor | Awaiting receipt of timer |
Established in
